Using solo with cascade, Cascade block diagram, Cascading the 03d – ALESIS 03D User Manual
Page 239
Cascading the 03D
229
03D—Owner’s Manual
Using Solo with Cascade
When two consoles are cascaded together, the Solo buses of both consoles are con-
nected. Solo mode is engaged using the [SOLO] button on the master console. The
[SOLO] button on the slave console is essentially redundant. Also, solo Status settings
must be made on the master console. Listen, Sel mode, and safe channel settings, how-
ever, are made on the respective console.
1. Set the Solo Status on the Solo Setup page of the cascade master.
This setting cannot be made on the cascade slave.
2. Press the [SOLO] button on the cascade master.
3. Use the [SEL] buttons on each mixer to solo channels.
Solo signals are output through the monitor section of the cascade master.
4. Press the [SOLO] button on the cascade master to cancel solo.
Cascade Block Diagram
SOLO
SELECT
ON/OFF
PAD
INPUT
OUTPUT
(CD8-CS)
(CD8-CS)
R
L
ST
R
L
EFF
AUX
1 2
1 2 3 4
BUS
4
3
2
1