ALESIS 03D - Manual (Page 236)

226
Chapter 18—Digital I/O
03D—Owner’s Manual
Installing YGDAI Cards
1. Turn off the 03D.
2. Undo the four fixing screws and remove the slot cover, as shown below.
Keep the cover in a safe place for future use.
3. Insert the card into the slot as shown below. Push it in all the way so that
the card’s connector mates correctly with the internal 03D connector.
4. Secure the card using the four fixing screws.
5. Turn on the 03D.
The 03D checks to see what type of YGDAI card is installed when it’s turned on. If
installation is successful and the card is working correctly, the card type appears on the
D.out Setup page. See Assigning Signals to the YGDAI Outputs on page 224 for more
information.
Warning: Turn off the 03D before installing a YGDAI card. Failure to do so is an electrical
shock hazard, and may damage the 03D or card.