eLine Technology ANPTZ-70-10DN - Manual (Page 19)

13
Installation
En
gl
is
h
5. Drill holes for the mounting
screws (x4) and the cables and
run the cables through the hole.
Ceiling/Flush
mounting
screws
6
6. Attach the camera base to the
surface using the included
ceiling/flush mounting screws
(x4).
NOTE: Use the included dry wall
anchors if installing the camera in
drywall.
7. Connect the video and alarm
cable connectors to the camera.
7
NOTE: Make sure power is
disconnected before connecting
the video cable. Camera will begin
moving immediately when power is
connected.
8. Attach the camera to the
base using the base
attachment screws (3x).
Base attachment
screws
8
14
Installation
9. Reattach the dome cover by
rotating it clockwise.
Remove protective vinyl from
dome cover.
9
10.Connect cables as shown in
“Connecting the Camera” on
page 2.
eLineTechnology.com