eLine Technology ANPTZ-70-10DN - Manual (Page 33)

27
Using the OSD Menu
En
gl
is
h
5.3.4 SWING SETUP
You can setup up to 8 swings.
During a swing, the camera moves between 2 Preset positions
repeatedly. When Swing function runs, the camera moves from the
preset assigned as the 1st point to the preset assigned as the 2nd point
in CW (Clockwise) direction. Then, the camera moves from the preset
assigned as the 2nd point to the preset assigned as the 1st point in CCW
(Counterclockwise) direction.
If the preset assigned as the 1st point is the same as the preset assigned
as the 2nd point, camera turns on its axis by 360° in CW (Clockwise)
direction and then it turns on its axis by 360° in CCW (Counterclockwise)
direction.
Speed can be set up from 1° / sec to 180° / sec.
To run a swing using keyboard controller shortcuts:
• Press [141~148] and then press [Preset] to runs swings 1 ~ 8.
To create swings:
1. Setup the desired presets you would like to use to create Swings.
28
Using the OSD Menu
2. Go to the Swing Setup menu (Menu>Dome Camera Setup>Swing
Setup).
3. Configure the following:
• SWING NUMBER [1~8]: Selects Swing number to edit. If a selected
Swing has not defined, NOT USED is displayed under 1st Position and
2nd Position.
• 1ST/2ND POSITION [PRESET 1~128]: Set up the 2 positions for Swing
function. If a selected preset is not defined, UNDEFINED will be
displayed under the 2nd Position.
• SWING SPEED [1°/sec~180°/sec]: Sets Swing speed from 1° / sec to
180° / sec.
• CLEAR SWING [CANCEL/OK]: Select OK and press [Near] to delete
current Swing data.
5.3.5 PATTERN SETUP
You can set up to 4 Patterns with a maximum of 1200 communication
commands each.
Creating a Pattern memorizes a path (mostly curve path) defined by the
keyboard controller to be run later.
Patterns can be created using keyboard controller shortcuts or the OSD
menu.
eLineTechnology.com