EXP Computer ThinFax LXM - Manual (Page 20)

Hardware Installation
1. Locate the PC Card (PCMCIA) slot, which is usually on one side of
the computer. Some PC Card (PCMCIA) systems allow "hot
insertion" (inserting the card while PC power still on).
Consult your computer User's manual for details.
If you are in doubt, turn the power off.
2. Align the modem card with the arrow sign pointing toward the
computer's slot. (Please note that the card is keyed to guide the
proper installation.)
3. Slowly insert the modem card into the slot and press firmly until
the modem
=s connector is seated.
4. Insert the modem =s cable into the card.
Hardware Installation (Cont)
5. Connect RJ-11 connector to a working telephone line. ( If you are not
planing to use the modem at this time. You may skip this step.)
6. You are now ready to install either the computer manufacturer's
Device Driver (If they are Not pre-loaded from the factory) or the
EXP's ThinFax Device Driver. Please follow the Software
Installation Guide procedures.
Software Installation Guide
Installing the device driver for DOS and Windows 3.X
The EXP Device Driver Installation programs are designed to help you install
the device driver into the computer with ease. The programs present you with choices
of specific manufacturers and models of the computers. EXP also has a generic driver
available in case your specific computer is not on this list.
1. Insert the device driver diskette into the floppy drive.
2. Change the working directory to the floppy drive containing the device
driver diskette by typing a: or b:, then the Enter key.
3. At the DOS prompt (A:\> or B:\>), type INSTALL followed by the Enter
key. Press Enter again.
A selection menu will appear.