EXP Computer ThinFax LXM - Manual (Page 6)

Hardware Installation (Cont.)
Inserting the Card
Hold the card with the EXP logo on the top. Slide the card into the slot located at the
left side of the HP 100/200LX. Push the card in until the end of the card is flush with
the case. (See Below)
Removing the card
Slide the ejection button to the left until the end of the card clears the case.
Software Installation
To install the ThinFax card:
C Press the &… , MENU, A, L key. To close all applications.
C Press &… , D to display DOS prompt C:\.
C Type A: and press Enter, Change to drive A: in the ThinFax 1414-
LX/LXM card.
C Type INSTALL and then press Enter.
The installation program will check the existence of the c:\config.sys and
c:\autoexec.bat file. If the files are not present, the install program will copy them
from the D: drive to C: drive and/or activate the TSR program by erase the word
>REM= from the c:\autoexec.bat (HP 100LX only) line:
REM d:\bin\cic100 /gen1
If you have ThinFax 1414-LXM, beside performing the above procedures, the
install program also sets up the FLASH memory as the F: drive (typical) in your
HP 100/200LX palmtop computer by adding a statement into the C:\config.sys
file:
Device=c:\tflxm\lxmdrv.sys
Along with the driver, a format utility is also included. These two files will be
installed in the C:\tflxm directory:
lxmdrv.sys (device driver for HP Palmtop)
lxmfmt.exe (format utility)
The screen should display the following lines:
<< EXP ThinFax LX, LXM card installer v1.2* >>
Processing AUTOEXEC.BAT...
Create C:\TFLXM
Processing CONFIG.SYS.........
Press any key to reboot....
The card is now ready to use.
* The actual version may be different.
The Flash size displayed depends on your card type.