EXP Computer ThinFax LXM - Manual (Page 22)

CHECKING YOUR MODEM INSTALLATION
After installation, you may wish to check if the computer recognized the
modem and the assigned COM port.
Click on Start => Settings => Control Panel => Modem => Diagnostics tab.
Locate the modem’ s COM port then highlight it. Click on ‘More Info... button.
The Windows 95 will try to communicate with the modem. The More Info... window
appear with all the modem identification information.
The modem is now installed properly and ready. If you have a program that required
modem, please check your COM port setting. Match the COM port and the IRQ
(Interrupt Request) setting for the modem in the ‘More Info.. window.
IF SOMETHING GOES WRONG
In case of difficulty such as after you inserted the card and there is NO “New
Hardware Found” window pop-up or there is no information about the modem. Please
check the PCMCIA Socket support, the 32-Bit Card support may not enable or working
properly. Follow the instruction for enabling the Socket support.
ENABLING 32-BIT CARD SUPPORT OF WINDOWS 95
Your system should be ready for PCMCIA socket support prior to operating the
ThinFax Modem. To check whether your computer is PCMCIA Socket supported, first,
double-click on the “System” icon from “Control Panel” folder (you can select the
“Control Panel” under “Settings” from the “Start” menu to open the “Control Panel”
folder).
Click on the Device Manager Tab. If “PCMCIA Socket” is found with a cross (X) sign
next to the PCMCIA Controller as show above, it means the PCMCIA device driver is
not using 32-Bit Card Support. The socket(s) is not function properly. There should be
only one such a line displayed.
In this case, double click on the PCMCIA Controller, and a dialog box will be displayed
as below. Please place a check mark next to the current configuration of Device usage
box, then select OK.
After the PCMCIA 32-Bit Card support is installed, Windows will ask you to reboot
your computer. Then you should repeat the install procedures.
If the PCMCIA Socket is not found, then you must add a PCMCIA socket to your
system. Please click on the “Add New Hardware” icon in the Control Panel folder and