Burkert Type TAT002 - Manual (Page 15)

0911 - 13
english
Measured value display
OPb calibration of the sensor regardless of the measurement range
P3F Third terminal of a no = Pt100 2-conductor wired
Pt100 sensor yES = Pt100 3-conductor wired
(if present)
Digital inputs
HES Temperature increase/ Set-value is increased/lowered by HES
Reduction during the energy saving phase.
Activation via digital input
(i1F = Es).
i1F Function of the digital EAL = external alarm; OFF = unused;
Input bAL = serious external alarm;
Es = Energy saving mode Start/Stop;
onF = switch the device ON/OFF
externally;
C-H = reverse the control effect
i1P Polarity of the digital CL: active with closed contact
input OP: active with opened contact
did Alarm delay time For i1F = EAL or i1F = bAL.
of the digital input The corresponding alarm then takes
(0...120 min) place display or message.
Miscellaneous
Adr Serial address RS485 Address for XJ500 recording
(1...247) system. Identifies the device if it
is linked into a ModBUS-compatible
system.
OnF Set device to STAND-BY no = not possible via keyboard
yes = STAND-BY can be activated by
holding down the SET button for at least
4 sec. If you want to change the set-
value, hold down the SET button for 2
sec.
Ptb Number of the parameter- only read-out value
table
rEL Version only read-out value
Pr2 Display of the parameters
in Level Pr2
display only