Hydrotech Classic Series Stenner Basic Service Manual - Manual (Page 24)

23
Tube Replacement and Centering
Removing the Old Pump Tube
1. Turn pump off.
2. Remove screws and then the cover by lifting the side
opposite the tube fittings.
3. Set the feed rate dial on a low setting and leave on this
setting until finished.
4. Turn the pump on and let it run until one of the three slots
in the roller assembly lines up with the bottom tube fitting
(suction side).
BEST PRACTICE
Factory recommended
Prior to tube removal, pump water
through tube to remove chemical.
Continued...