Clear-Com HX System Frames User Manual
Eclipse hx-omega user guide
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 1 Important Safety Instructions
- 2 Introduction
- 3 Overview
- 4 Installing the Eclipse HX-Omega
- 4.1 Before you begin the installation
- 4.2 Installing the Eclipse HX-Omega
- 4.3 Installing CPU cards
- 4.4 Installing interface cards
- 4.5 Wiring audio devices to the matrix
- 4.6 Wiring panels to the matrix
- 4.7 Wiring CPU card interfaces
- 4.8 DSE1/T1 Matrix to Matrix crossover cable connections
- 4.9 E1/T1 Matrix to Matrix straight cable connections
- 4.10 E1 to FreeSpeak / CellCom antenna straight cable connection
- 5 Using the Eclipse HX-Omega
- 5.1 Creating and storing system configurations
- 5.2 Setting the default IP Address
- 5.3 Using the CPU card Ethernet ports
- 5.4 CPU card fail-safes
- 5.5 CPU card lights and controls
- 5.6 Analog port card (MVX-A16) front-panel lights and controls
- 5.7 Power supplies
- 5.8 Diagnosing power supply problems
- 5.9 Connecting the matrix
- 6 E-MADI64 card
- 7 E-FIB fiber card
- 8 E-QUE E1 / T1 card
- 8.1 Supported FreeSpeak / CellCom connection options
- 8.2 Supported direct and trunk connections (using the E1 and T1 protocols)
- 8.3 E-QUE front panel lights and controls
- 8.4 E-QUE rear panel connectors
- 8.5 Synchronization
- 8.6 E-QUE interface applications
- 8.7 E1 Trunk and Direct Modes
- 8.8 T1 Trunking
- 8.9 Trunking failover
- 9 IVC-32 card for IP-based connections
- 10 LMC-64 metering card
- 11 Maintaining the Eclipse HX-Omega
- 12 Specifications
- 12.1 Matrix capabilities
- 12.2 Mechanical
- 12.3 Environmental
- 12.4 Matrix performance
- 12.5 E-MADI64 interface front card
- 12.6 E-MADI64 interface rear card
- 12.7 E-MADI64 fiber cable
- 12.8 E-MADI64 fiber transceiver
- 12.9 E-MADI64 clock sources
- 12.10 Fiber interface front card
- 12.11 Fiber interface rear card
- 12.12 Fiber cable
- 12.13 Fiber transceiver
- 12.14 E-QUE interface front card
- 12.15 E-QUE interface rear card
- 12.16 IVC-32 interface front card
- 12.17 IVC-32 interface rear card
- 12.18 LMC-64 interface front card
- 12.19 LMC-64 interface rear card
- 12.20 Analog port card (MVX-A16)
- 12.21 Data interface: 16 bi-directional
- 12.22 Backplane connector: FCI/BERG Metral
- 12.23 System programming
- 12.24 Minimum PC requirements (for EHX software)
- 12.25 Recommended PC requirements (for EHX software)
- 12.26 Power supply unit
- 13 Glossary