Clear-Com FreeSpeak Beltpack - Manual (Page 23)

Clear-Com Communication Systems
Eclipse Wireless Communication System 1 - 5
BELTPACK REAR/BATTERY SECTION
Figure 1-5: View of Back of Beltpack
Power Button
The recessed power button is used to turn the Eclipse beltpack on and
off. Press and hold the button for about three seconds to turn the unit
on. To turn the unit off, again press and hold the button for about three
seconds.
Battery Case
The removable battery case will hold four alkaline AA or four NiMH
(nickel-metal hydride) rechargeable batteries. These batteries
alternate, with the negative pole contacting the spring and the positive
pole contacting the plate inside the case.
To remove the battery case, press on the top of the belt clip to lift it off
the case, and with the thumb and middle or ring finger of the other
hand squeeze the side tabs of the case and lift it out, slightly tilting the
lower (toward the bottom of the beltpack) portion of the pack out first.
To insert the battery pack, follow the above instructions in reverse.
Note that the battery case has a clip-on lower cover; make sure to put
it back in place before putting the battery case back into the beltpack.
Caution: Do not put battery packs containing alkaline batteries
into a recharger, or recharge them in the beltpack. Serious
damage or injury could result.
1
2