Matrix (eclipse base) connector, Transceiver/antenna connectors, Splitter rear panel – Clear-Com FreeSpeak Beltpack User Manual
Page 60: Serial data connector, Power indicator, Matrix (eclipse base) connector -6, Transceiver/antenna connectors -6, Splitter rear panel -6, Serial data connector -6, Power indicator -6
Clear-Com Communication Systems
Eclipse Wireless Communication System
3 - 6
Matrix (Eclipse Base) Connector
This RJ-45 connector accepts a 4-pair data cable from the Eclipse
matrix E-Que port. This cable can be up to 1,000 meters in length if 24
AWG cable is used or up to 500 meters if 26 AWG cable is used.
Splitter-to-Transceiver/Antenna Signal Indica-
tor Light
These yellow lights indicate that a connection from the Eclipse base is
available to the particular transceiver connected to that port.
Transceiver/Antenna Connectors
These five RJ-45 connectors are used to connect up to five remote
transceiver/antennas to the splitter, and via the splitter to the Eclipse
matrix. Each of these cables can be up to 1,000 meters in length if 24
AWG cable is used or up to 500 meters long if 26 AWG cable is used.
SPLITTER REAR PANEL
Serial Data Connector
This 3.5 mm (1/8 inch) tip-ring-sleeve (TRS) connector is used for
upgrading the firmware in the splitter. It will typically be unused.
Power Indicator
This green LED indicates that the splitter is receiving power from the
external power supply.
2
3
4
1
2