Master button operation – INSTEON Wireless Thermostat with Humidity (2441ZTH) Manual User Manual
Page 10
Page 10 of 27 Rev: 1/21/2014 8:36 AM
Hold button operations
•
The Hold button is only functional in Auto Program mode
•
The Hold button overrides a preprogrammed mode until Hold is turned off
IMPORTANT:
•
While Hold is enabled, the next preprogrammed time that comes in Preprogrammed Auto Mode will
be ignored.
•
While Hold is enabled, the preprogrammed time notations are not shown (i.e. Wake, Leave, Return
and Sleep).
•
Hold can be remotely enabled/disabled from an INSTEON controller.
Master Button Operation
First press and hold:
Makes the local INSTEON Wireless Thermostat the master temperature controller
•
To perform this, press and hold Master button for 3 seconds.
INSTEON Wireless Thermostat will beep once.
•
Release.
Note: This is only valid if INSTEON Wireless Thermostat is linked to a INSTEON Thermostat.
Before pressing Master button:
•
Notice that the left remote sensor is currently
the Master temperature controller
After pressing and holding Master button:
•
Notice that the left remote sensor is no
longer the Master temperature controller
•
The local INSTEON Wireless Thermostat is
now the Master controlling temperature
Note: If no INSTEON scene is programmed to an INSTEON Wireless Thermostat, pressing and holding
for 3 seconds will have no function.