INSTEON Wireless Thermostat with Humidity (2441ZTH) Manual - Manual (Page 8)

Page 8 of 27 Rev: 1/21/2014 8:36 AM
Third press of Time/Sensor:
Clock Format setting (12- or 24-Hour clock)
• Entire time line blinks
• Up/Down arrows cycle between 12- and 24-hour clock format
Note: AM/PM is not displayed when in 24-hour format.
Program Button Operation
• The Program button allows you to set up the various preprogrammed modes (Wake, Leave, Return
and Sleep).
• Go to the next step by pressing Program again.
• Exit Program setup by:
- Letting it time out after 4 minutes.
- Pressing Mode button
IMPORTANT! Once you have added INSTEON Wireless Thermostat to a scene in INSTEON Thermostat
as a wireless temperature zone, the Program button will no longer function. All program controls will be
performed on the INSTEON Thermostat.
Note: Text colors below indicate element that is presently blinking during setting procedure.
First press of Program:
Selects from available pre-program modes
Up/Down arrows cycle through Wake, Leave, Return and Sleep.
NOTE:
• Energy is not a part of this option
• Once a preprogrammed mode is selected, that item remains displayed throughout to
indicate the mode you are programming
• The current mode settings are displayed on the thermostat at each setup step
Second press of Program:
Start Time
• Up/Down arrows cycle through time in 15-minute increments. Note: when pressing the Down arrow, if
you come within 15 minutes of another preprogrammed mode time, you will not be able to increase
the time any further.
• Pressing and holding Up/Down arrows cycles through faster
Note: AM/PM changes automatically as needed.