INSTEON Wireless Thermostat with Humidity (2441ZTH) Manual - Manual (Page 23)

Page 23 of 27 Rev: 1/21/2014 8:36 AM
Battery 2 AA cells (quality alkaline recommended)
External Power Supply 4.5 to 7.5 volts DC, 200mA
Load type(s) N/A
Maximum load N/A
Minimum load N/A
User replaceable fuse No
Hardwired remote control N/A
Retains all settings without power Yes, saved in non-volatile EEPROM
Standby power consumption
22 micro-Amps (on battery power)
20mA (on external power, not in sleep mode)
Certifications
FCC ID Pat 15B & 15C and IC: RSS-210 Issue 8 (US/Can)
ETSI EN 300 220-1 & 220-2, ETSI EN 301 489-1 & 489-3 (Eu)
AS/NZ 4268 (C-Tick N16509)
FCC ID SBP2441ZT
Marks
WEEE, RoHS (All models)
C-Tick N16509 (Aus/NZ model)
Safety approval(s) N/A, low voltage device
Troubleshooting
Problem Possible cause Solution
After powering up or a factory
reset, INSTEON Wireless
Thermostat displays a two-digit
error code instead of the ambient
temperature. It didn’t boot up fully. Remove batteries from INSTEON
Wireless Thermostat, wait a few
seconds, then reinstall. If
problem persists, call the
INSTEON Support Line.
I replaced my INSTEON Wireless
Thermostat with a new one, but
now the INSTEON for Hub app
doesn’t recognize it. The INSTEON for Hub app
communicates via INSTEON
I.D.s. They are still trying to
communicate to the old
thermostat’s I.D. Update the INSTEON I.D. on
both the Hub and the INSTEON
for Hub app with your new
thermostat’s I.D.
My INSTEON Wireless
Thermostat temperature reading
is taking a long time to update on
my INSTEON Thermostat
display. At the top of each hour and, :15,
:30, and :45 past, the INSTEON
Wireless Thermostat will wake up
and synchronize the readings
with the INSTEON Thermostat
display. For an immediate update, press
the temperature up or down
button
INSTEON Wireless Thermostat’s
battery life seems very short. Battery life depends on individual
settings (such as LED backlight
display on-time, notifying Change INSTEON Wireless
Thermostat settings to reduce
battery consumption.