King Technology New Water Models 400/430 User Manual
Page 11
11
SCOOPS
2” – 36” APART
ON STRAIGHT PIPE
Screw elbow into reducer
bushings on both sides.
Cut tubing
to size for
each New
Water®
Cycler
connection
and attach
one to
each
elbow with
clamps.
Tighten clamps
with a screwdriver.
When pipe is
totally dry, drill two
19/32” or 5/8”
holes, between
2” - 36” apart, on
the return line. Be
careful not to go
through other side
of pipe.
Attach a gasket to
each scoop.
Place scoops inside
holes so the inlet
scoop faces the water
flow and the outlet
scoop faces away
from the water flow.
Scoop arrows should
be facing each other
when correct.
2” – 36” apart on straight pipe
Arrows on scoops must face
each other.
Attach scoop clamps
over the scoops and
around the pipe.
Tighten scoop clamps
with a screwdriver.
Attach each hose to venturi
scoop male nipple with a
small clamp and tighten with
screwdriver.
For best results use Phillips
pan head screws through the
mounting holes in the New
Water® Cycler base to secure
the New Water® Cycler into a
treated wood base.
Isolating the New Water® Cycler by installing a corrosion
resistant check valve is recommended.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.