King Technology New Water Models 400/430 - Manual (Page 16)

16
Winterizing
1. Hold cap in front of you
upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and index finger of one
hand.
2. Take hold of the far end
of the o-ring with the thumb
and index finger of the other
hand. Roll o-ring slightly back
towards you as you stretch
the o-ring into the remainder
of the cap groove.
3. Lubricate o-ring often with
silicone lubricant that came
with your New Water® Cycler.
DO NOT USE petroleum based
lubricants.
Replacing Cap O-ring
Replacing Knobs • To replace, simply unscrew old knob
and replace with the new one.
• Front of 120 Cycler
• Back of 120 Cycler
• Back of 400/430 Cyclers
and Cap of 400/430 Cyclers
1. Turn dial to minimum
or 0. Turn pump off.
Unscrew back knob of
Model 120 to relieve
pressure.
2. Remove cap.
3. Unscrew knob in back
of Models 400/430 or
from the front of Model
120. Allow all water to
drain.
4. Remove Pac.
5. Replace the cap and
knobs loosely.
6. If Pac still contains
chlorine wrap in
plastic bag and store
in shed or cool well-
ventilated location away
from children, pets,
motorcycles, cars or
anything metal that can
rust, pit, etc. Make sure
the Pac is away from
open flame.
Models
400/430
Model 120
SILICONE
LUBRICANT
MIN. MAX
Model 120 Models 400/430
®
Models
400/430
Model 120
Models
400/430
Model 120