King Technology New Water Models 400/430 - Manual (Page 13)

13
CYCLER
Metered Pool Purifier
New
W ater
®
400 SERIES
USE ONLY CYCLER PAC 400 SERIES
Finished cut ends
Pac
towers
Pac
towers
Key in
Cycler
Opening
in Pac
A correct
oval
opening
Avoid a
pinched
opening.
Indent in plastic
MIN. MAX
®
®
Model 120 Model 400
Model 120 Model 400
Model 120 Model 400
Replacing a
Cycler Pac
1.
Turn off pump. Turn dial to
Minimum or 0. This reduces the
flow of water into the unit when
the cap is open.
USE ONLY the factory recommended replacement New Water® Cycler Pac. (See label.)
DO NOT USE any other pack or bulk chemical tablets in the New Water® Cycler. Use
of any other product could result in over chlorination, bleached liners, unsafe pool
conditions, fire or explosion. Warranty will be void if the correct New Water® Cycler Pac
is not used.
Open the cap. For in ground pools use the
cap tool included with cycler to loosen cap by
hitting the handle with the flat of your hand
counter clockwise. Stand back upon removing
cap to avoid inhaling fumes. The chlorine pacs are made
of HDPE plastic. Non-refillable
container. Do not reuse or
refill this container. Offer for
recycling if available. Rinse
thoroughly before recycling or
discarding in trash.
2.
3.
4.
Cut handle from New Water® Cycler Pac using a PVC cutting tool or a hacksaw (KEEP OUT OF REACH OF CHILDREN)
A. Find the
indent in
the plastic.
B. If using a cutting tool, place
curved section of tool around
the narrow end of one pac tower
and line up blade on indent C. Squeeze the handles
together. Repeat for other
side. D. If using a hacksaw to cut
the pac, line up hacksaw
blade on indent and cut with
a smooth sawing action.
E. Whether using a cutting
tool or a hacksaw, make sure
the blade comes straight
across on the indent line for
a clean cut. F. If openings are pinched
together, open with fingers or
re-cut closer to the colored
screens inside pac. Leave
at least 1/4” of plastic to fit
into cycler base.
5.
Turn pac over and shake
slightly until tablets fall into
tower areas.
Insert pac into cycler, lining
up the openings in pac with
keys in cycler.
NOTE: Openings are a
different shape than keys.
Avoid sparks, open flame or
smoking when handling the
pac.
Replace cap by hand only.
DO NOT OVERTIGHTEN. DO NOT USE CAP TOOL TO
TIGHTEN CAP.
FOR REMOVAL ONLY.
6. 7.
PVC cutting tool
available at local
hardware stores.