King Technology POOL FROG Mineral Hybrid System Digital - Manual (Page 11)

11
����
����
����
�����
�����
�����
�������
���������
��������������
�������������
POOL FROG® Mineral Hybrid Cycler Maintenance
1.
2.
3.
Replacing the Control Dial O-Rings
Using a needle nose pliers,
find the snap ring tail located
at approximately the five
o’clock position under the
control dial.
Pull down and out of the
groove.
Using a large screwdriver,
loosen the control dial.
Carefully pry the dial until it
pulls out.
Carefully replace the rubber
oring without stretching it.
Apply silicone lubricant, that
came with your POOL FROG®
Mineral Hybrid Cycler, on
o-ring. DO NOT USE
petroleum based lubricants.
Push control dial completely
into the housing and turn the
dial to setting 2.
Replacing Cap O-Ring
Lubricate o-ring often with
silicone lubricant that came
with your POOL FROG®
Mineral Hybrid. DO NOT USE
petroleum based lubricants.
Replacing Knob
Replace knob in back or on
cap of POOL FROG® Mineral
Hybrid Cycler by unscrewing
old one and screwing in new
one.
Hold cap in front of you
upside down with the o-ring
groove facing up. Place
one end of o-ring into cap
groove at the point closest
to you. Hold o-ring down
with the thumb and index
finger of one hand.
Take hold of the far end of
the o-ring with the thumb
and index finger of the
other hand. Roll o-ring
slightly back towards you as
you stretch the o-ring into
the remainder of the cap
groove.
Insert the non-lipped end of
snap ring into the groove
opening beginning at the
5 o’clock position and push
it up so that it threads itself
around the control dial.
Using a small screwdriver or
pointed tool to help guide it,
make sure the snap ring stays
in the groove as it is inserted.
Turn the dial back to MAX.
1.
2.
3.
4.
5.
6.
7.
���� ����
����
�����
�����
����� �����
��������
���������