King Technology POOL FROG Mineral Hybrid System Digital - Manual (Page 10)

10
Cleaning POOL FROG® Mineral Hybrid Cell
Our clear cell allows for easy regular inspections for calcium build up. Visually check the cell periodically, and clean it as
necessary (1 to 2 times per year).
Do Not use metal or other hard objects to clean
the cell.
Do Not insert anything into the cell. These actions
could scratch the precious coating on the plates and
void the warranty.
WARNING!
Always add acid to water, NOT water to acid.
Diluted muriatic acid solution = 10 parts water to
1 part acid.
Note: Follow the instructions of the acid manufacturer.
WARNING!
Always use protective eyewear and protective
clothing.
WARNING!
1. Before removing cell, turn off power to pump and control
panel of generator. Make sure to note in which direction
the cell was installed so it can be replaced correctly.
2. Remove the cell from the line by
unthreading the barrel unions from the cell
ends. There is no need to remove the
electrical wire connections.
3. Remove the black o-ring on one end
of the cell.
4. Attach the cell Cleaning Cap to the
other end of cell.
5. Put on rubber gloves and goggles.
6. Pour into cell, either undiluted
white distilled vinegar, or a solution
of diluted muriatic acid (10 parts
water to 1 part muriatic acid).
7. Wait for foaming to stop (5-10
minutes when using muratic acid
– vinegar takes longer).
8. Safely dispose of muratic acid
by pouring it into your pool only.
If using vinegar dispose of by
pouring down your kitchen drain.
9. Rinse cell with water hose.
Avoid contact with skin or clothes.
10. Put the o-ring back in place and re-install the cell
in the line making sure the water flows into the square end
of the cell first.
11. If the wire connections were removed, make sure they
are clean and free of debris before reconnecting them (see
cell wiring diagram below).
NOTE: Lubricating the o-rings with the silicone lubricant that
came with your POOL FROG® Mineral Hybrid helps improve
the seal of the fittings, but be sure not to use silicone glue,
petroleum jelly (such as Vaseline), or other agents that
could deteriorate the o-rings.
CELL WIRING DIAGRAM