KT&C KPT-SPDN120HD - Manual (Page 16)

3. Program and Operation
3.1 Getting Started
You should install and connect the dome to an interface device before using this operating guide.
Refer to {2. Installation and connection of this manual}.
Once installed, apply power to the dome and the start-up screen is displayed on the monitor.
Before installing and operating the dome camera, please read this user’s manual carefully.
This dome camera can be operated using two methods:
- Use hot keys [Refer to Appendix].
- Use OSD Menu on the monitor [Read this operation manual].
* Notice: You shall check the saving state of each step at sub menu or edit menu, after editing
functions or changing settings. You may save setting one function twice. For example, after {the
position or title of Preset} is saved at ‘Sub Menu’, {the status of Preset Setup} has to be saved at ‘Preset
Setup Menu’ again.
* Notice: To stop an action, press [ESC] button or [96+Preset]. In that case, the dome goes to
manual mode or is to be paused temporarily (about 10sec in Alarm mode)
3.1.1 ACCESSING MAIN MENU [95] + [Preset]/ [Menu]
When you use Pelco-D and Pelco-P protocol with your controller, you can access to the main
menu on your monitor by pressing the key [95] + [Preset] or pressing and holding the
[Menu] key for 2 seconds.
3.1.2 Editing TITLE
The title edit menu can be used in the setup for Preset / Pattern / Tour / Scan commonly.
- Move the joystick right in Main Menu. The screen appears on the monitor:
- Move the joystick right, left, up or down to select a character.
- Press [Tele] button to input a character and [Wide] button to cancel the character.
- When the label is completed, use [Near] or move the joystick to save the selected title.
- If you want to cancel the selected title, return to the previous menu using [Far] button.
16
X12 MINI SPEED DOME
V x.xx.xx
RS485/2400
1080P 30HZ
ID001
CAM TEST ...PASS
TITLE
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789/+-=;?#.,"~0
SELECT : (MOVE)
SET/CLEAR: (TELE/WIDE)
SAVE : (NEAR)
EXIT : (FAR)