KT&C KPT-SPDN120HD - Manual (Page 31)

3. Program and Operation
3.11 Alarm Menu
▲ / ▼: move joystick up and down for selecting an item.
◀ / ▶: move joystick left and right for moving an item.
▶ / [Open] / [Near]: move joystick right to select or save settings or go to edit pages.
▶ / [Close] / [Far]: move joystick to cancel or to exit current menu (Back).
- Enter into {Main Menu}
- Using the joystick [▶], select Alarm Input type (NO / NC).
- Using the joystick [▶], select Alarm Output (On / Off)
- Alarm priority can be set using the joystick [▶],
Change an action / number {Off, Preset, Pattern, Scan, or Tour}.
- Set Alarm action time (Dwell Time): 3~60sec / On, default setting is ‘ON’.
-> Time Out (3~60sec): This is activated during a period of a selected dwell
time when an alarm is triggered.
-> Momentary (On): When an alarm is triggered, the dome camera will
maintain alarm activation continuously, until it is stopped manually
(96+preset or / and changing in alarm menu).
- It is possible to clear saved {Alarm No.xxx}, pressing [Wide] button at a position of
{No.xxx} individually.
- Press [Open] button or use joystick [▶] to save settings.
- Press [Close] button or use joystick to return to previous menu (Back).
* Notice:
In order to call an action (Preset, Pattern, Tour or Scan), you must save Preset, Pattern, Tour, or
Scan first. To pause alarming (about 10sec) temporarily, press [ESC] button or [96+preset].
* Notice:
The dome camera normally supports 4 Alarm Input (AL0~3). But AL3 can be used as Digital input
for External D/N, so, in this case, Only AL0~2 are available for Alarm inputs.
31
ALARM SETUP
NO. 001 : NOT USED
IN :
OUT :
PRIORITY :
ACTION :
NUMBER :
DTIME :
SAVE : OPEN
BACK : CLOSE
- SET/CLEAR : (TELE/WIDE)