KT&C KVR-0412H - Manual (Page 191)

191
 (SCAN): Press number Key and SCAN then the designated Scan will run.
 (HOLD): Press HOLD to lock the Keyboard. To unlock user has to input Password. (Default password is 0000)
 : Press NEAR/FAR to adjust the focus of Speed Dome camera.
 : Press TELE/WIDE to adjust the zoom of Speed Dome camera.
NOTE
 SPD Control Mode is only supported when Speed Dome Camera is directly connected to CP1300.
WARNING
 Depending on the Protocol being used by the Speed Dome camera, controlling camera menu will differ. Please check
Speed Dome camera manual.
NOTE
 When a Key does not Work after Set up
- If the communication speed of DVR and CP are not co-related, it may not work. Please make sure the Baud rate of Keyboard sets on
9.6kbps.
- Press the button to enter PTZ mode and switch to DVR mode again.
- Please reboot the DVR.
 When Tx Blinks Continually on the LED Window
- If Tx blinks continually without any operation, it may be caused by improper set up of Joystick.
- OFFSET of the Joystick may not appropriately set up.
- Please do Joystick calibration.