KT&C KVR-0412H - Manual (Page 37)

37
NOTE
Notify setting does not affect saving the recorded data. It only gives notification and keep recording until hard disk is full.
NOTE
For more specific setting about Alarm-out, use Setup>DEVICES>Alarm Out.
Clear All Data
 Use to delete or purge all normal recorded data from database. Please follow the procedure below.
① Click ( ) Clear All Data frame.
② When a dialogue box asking “Remove All Data?” shows, choose ‘OK’.
③ Then, Progress window will appear and the process starts.
④ When all data are deleted, a dialogue box asking “Are you sure to remove log?” will pop up.
⑤ Choose ‘OK’ to delete all the recorded data as well as System Log.
 When user finished all the necessary inputs to SYSTEM menu, please click ( ) ‘OK’ on the bottom to go back to SETUP
screen.
NOTE
This might take a while to completely delete all data, and DVR will reboot after the data is cleared.
CAUTION
DELETED DATA CANNOT BE RESTORED .
4.2.2 Admin
 Please click ( ) SYSTEM>Admin and the following screen will appear.
Date
 This menu will allow user to adjust the settings.
 Please follow the procedure below for time adjustment.
① Click ( ) items (Y, M, D) to change. A designated item will be highlighted in a box (Y: Year, M: Month and D: Date).
② Adjust the number by clicking ( ) ▲, ▼ buttons on the right-hand side.
③ Repeat the same procedure to change Y, M and D.
Time
 This menu will allow user to adjust the current time. The adjustment procedure is same as of Date.
CAUTION
IF ADJUSTED DATE/TIME IS PRIOR TO RECORDED DATA, DATA AFTER NEW DATE/TIME MAY BE ERASED.
CAUTION
ANY CHANGE IN DATE/TIME IS IMMEDIATELY APPLIED ON VIEWING SCREEN (LIVE), BUT THE DATE/TIME WHEN THE RECORDING
WAS DONE IS NOT CHANGED. MAKE SURE TO REBOOT DVR AFTER CHANGING THE DATE/TIME. DO NOT FORGET TO EXECUTE
SHUTDOWN (SYSTEM>Shutdown) BEFORE REBOOT.
Date / Time