Cleveland Motion Controls Quantum Tension Controller REV A - Manual (Page 10)

10
Ent
Ent
1 – SET POINT Setting
4 – System General Settings
2 – Variable Setting
Hold for increase
Hold for decrease
Ent
• Press both buttons simultaneously
to enter the Data field (visible
underscore)
• Press once to increase/decrease
one digit
• Press to validate each digit
• Last digit validation sends the
complete value to the system
(underscore disapears)
3 – Additional functions
Press both buttons simultaneously to release the
system (Output = 0)
Press both buttons simultaneously to block the
system (Output = Max)
This value may be adjusted (see « SET POINT settings »)
Esc
Escape from releasing
Esc
Escape from Hold
Releasing Mode
Hold Mode
Esc
Escape from
Setting mode
MOTOR DIRECTION
- -> + / + -> -
MOTOR DIRECTION
- -> +
WIDTH COEFF
0 0 0
1 0 0
TAPER COEFF
0 0 0 , 0
HOLD
WIDTH COEFF
Ent
0 0 0
TAPER DIAM.
0 0 , 0 0 0
TAPER COEFF
1 0 0
0 0 0 , 0 _
HOLD
Initial readout
Ent
- - - - - - - - - - - - - - - -
- - - - - - - - - - - - - - - -
RECALL MEMORY Ent M1
Variable setting Esc
Variable setting
Variable setting
Variable setting
TAPER DIAM.
0 0 , 0 0 0
Esc
Esc
Esc
Variable
setting
Ent
M2 ... / ... M3 , M4, M5
MEMORY READ Esc
0 0 0 , 0
DISPLAY FILTER
0 0 0 , 0
DISPLAY FILTER Variable setting Esc
KEYPAD BASICS
www.cmccontrols.com