Cleveland Motion Controls Quantum Tension Controller REV A - Manual (Page 15)

15
1.0
Parameter
1.1 Communicate parameters to regulator
Save or load a set of parameters on the PC
To save a set of parameters, click in the thumb index 'file' then choose 'save as…' for recording
in a new file (file..PRM.), or 'recording' to record the set of parameters in the file in progress.
To open a set of parameters, click in menu 'file', then choose 'open…'. The set of parameters
will automatically load in the right interface.
The banks of memories of the regulator
There are five internal memories M1 to M5 in the QUANTUM. The memory in progress is
selected by the front panel.
Read the parameters of the regulator
PC software can read these 5 memory banks by clicking on 'read parameter' or in the thumb
index 'regulator' then 'read from regulator' and select the memory.
Send the parameters to the regulator
-To send a set of parameters, you can use the menu 'Regulator,' then 'send to regulator.' Then
select the memory bank in which you want to record the parameters. There is a direct access to
the memories in the icon bar (button 1 to 5).