Cleveland Motion Controls Quantum Tension Controller REV A - Manual (Page 21)

21
3.0 Menu DISPLAY
3.1 Units / Display
The front panel is used to display measurement values as well as different data used by the
Controller. These two menus (Units / Display) have to be used to choose what will be displayed
on the two available16 digits lines.
Units
This menu is used to choose the units for the measurement and for the diameter values.
Display
This menu is used to choose what information will be displayed on the two lines. On each line
it is possible to choose between the following options :
Display AO1 (idem AO2): Shows the analogic voltage output on AO1 output (resp. AO2).
Set point / Diameter / Measure: Shows the actual Set point / Diameter / Measure, using the
chosen unit.
Shows AO1 status (idem AO2): Shows the logic inputs configuration viewed by the Controller
(according to A / B digital inputs state), meaning HOLD mode, REGUL mode, RELEASING mode,
Estop mode.