Andrew ATC200-Lite - Manual (Page 15)

Bulletin 639510 May 2005 2-1
Section 2
Program Installation
2.1 Program Download and Installation
1. Download the zip file containing the ATC200-Lite setup file from the Andrew Corpora-
tion web site (www.andrew.com). This zip file can be placed in any directory on the PC’s
local C:\ drive.
2. Unzip the downloaded file to extract the ATC200-Lite setup file and its supporting instal-
lation documentation.
3. Double click on the setup file (eg. ATC200LiteSetup2_0.exe) to begin the installation pro-
cess. Note that the number shown in the filename, following ‘Setup’ and preceding the file
extension, represents the software release version.
During the program installation process, a single antenna definition file and additional
support files will self-extract into the same directory with the program file, and a program
icon will be placed on the PC’s desktop. The antenna definition file equips the program
with a drop down list of antennas compatible with the ATC200-Lite controller (also see
Section 3–Program Startup and Configuration). Tilt parameters for each antenna are
included in the antenna definition file to show the tilt range for each and to communicate
instructions to the antenna/actuator when tilt adjustments are made from the controller.
4. Follow the on-screen prompts, as shown in Figures 2-1 through 2-5, to complete the instal-
lation.
Figure 2-1. Install Shield Initializes.
Figure 2-2. Install Shield Prepares to Launch
Wizard.