Andrew ATC200-Lite - Manual (Page 41)

ATC200-Lite Teletilt ® Remote Control Downtilt System Section 6–Changing the Electrical Downtilt-Single
Bulletin 639510 May 2005 6-3
5. Click the ‘Activate’ button (Figure 6-2) to apply changes to the electrical downtilt for this
antenna. Alternately, to exit the screen without sending any changes, click on the ‘Close’
button. Antenna movement will begin after the ‘Activate’ button is applied.
A progress indicator bar (located under ‘Set Tilt’) will continually update for as long as the
move is in progress.
6. You will be notified when movement is complete (Figure 6-3).
If for any reason the move failed to reach the new downtilt angle specified, you will be
notified of the failure.
Click ‘OK’.
Figure 6-3. Electrical Tilt Adjustment Complete.
Click ‘Close’.
New tilt setting
becomes current tilt.
Figure 6-4. New Electrical Tilt Displays in ‘Current Tilt’ Field.