Andrew ATC200-Lite - Manual (Page 34)

Section 5–Device Configuration ATC200-Lite Teletilt ® Remote Control Downtilt System
5-2 May 2005 Bulletin 639510
Note the following in Figure 5-2:
• The ID of the device to be configured is displayed in the title bar of the dialog box.
• Devices that have never been configured before will display blank fields for all param-
eters, with exception to the ‘Mechanical Tilt’ field.– which will be set at ‘0.0’.
• Configuration items marked with an asterisk are required; saving a new configuration
will be disabled if any of these fields are blank.
• The ‘Installation Date’ field is handled differently from all other configuration items.
Although this field is not required, if no installation date has been saved on the actua-
tor, the program will suggest the current date as the default.
1. Make appropriate selections and text entries.
All configuration data is stored in the individual
device. An * denotes that the field must be
completed.
2. Click ‘Configure’.
Figure 5-2. Device Configuration Screen.