CNB SDN2712CD - Manual (Page 19)

9 / 16 Channel DVR User Guide
19
3-3. RECORD
Set the values for recording video. Navigate through menu items by pressing the UP/DOWN
buttons. User can change the value of the menu item by pressing the LEFT/RIGHT buttons.
Menu items in RECORD mode setup
RESOLUTION Set resolution.(352*240, 704*240 or 704*480)
CHANNEL Select the channel for applying the following settings.
FRAME RATE Set the frame rate. The sum of the frame rate values from each channel
cannot exceed maximum frame rates for a particular recording resolution. Typical
values of the maximum frame rate for NTSC video are 120/100 fps for
352*240(NTSC)/352*288(PAL) and 30/25fps for 704*480(NTSC)/704*576(PAL).
QUALITY Select the recording quality for the specified channel.
[Network, Standard, High, Superior and Ultra]
RECORDING Assign the recording mode for each channel.
[Continuous, Motion, Sensor, Schedule, and Disable]
MOTION ZONE Select Full Zone or Partial Zone for motion sensing.
Press SEL button to setup motion sensing area.
MOTION SENSITIVITY Set the motion sensitivity. Control the motion sensitivity from 1 to 9.
SENSOR RECORDING Select sensors to record for the specified channel.
You can set the sensor type from DEVICE setup menu.(none, N/O, and N/C)
PRE RECORD Enable/disable pre-event recording. Pre-event recording time is 5 seconds
and only intra-frames are recorded for pre-event recording.
POST EVENT RECORD Set post event recording time duration.(2 ~ 30 seconds)
AUDIO Enable/disable audio for the specified channel.
SCHEDULE Set recording schedule. Press SEL button to setup schedule.
Figure 3.3.1. RECORD mode setup screen
E
N
G
L
I
S
H