CognitiveTPG Advantage DLX - Manual (Page 8)

Copyright © 2009 CognitiveTPG - 1.800.732.8950 8
Chapter 2: Printer Installation
Setting up the Advantage DLX Printer
Connecting the Interface and Power Cables
IMPORTANT! PRIOR TO CONNECTING THE INTERFACE AND POWER CABLE TO THE
PRINTER, MAKE SURE THAT THE PRINTER IS TURNED OFF.
1. Connect the power cable to the AC adapter.
2. Connect the AC adapter to the power connector on the
printer.
3. Plug the power cable into an AC outlet.
4. Connect the interface cable to the rear of the printer. For
Serial or Parallel cables, securely fasten the interface
connector screws.
5. Test the Power by turning the power ON. The POWER
LED on the printer will turn green.
NOTE: IF THE POWER LED DOES NOT TURN GREEN REPEAT STEPS 1-5 OR REFERENCE
THE TROUBLESHOOTING CHART (CHAPTER 7).
Chapter
2