CONTREX ML-TRIM - Manual (Page 174)

Index - 6
Use the Setpoint Key..page 3-4
Use the Tach Key..page 3-4
Use the Up/Down Scroll Keys..page 3-4
I
I/O Power (J5 pins 1,2)..page 2-7
Input
Monitoring..page 3-40, Glossary-5
Test..page 4-7, Glossary-6
Inputs..page Glossary-6
Wiring..page 2-7
Installation
Calibration..page 2-17
Mounting the ML-Trim..page 2-3
Wiring..page 2-5
Integral..page 3-27, C-11, D-1
Interface with a Host Computer..page 3-49, 3-52
Internal Control Structure of the ML–Trim..page 3-43
Inverse Master Mode..page 3-22, 3-24
Inverse Scaling..page 3-22, 3-24, C-11
J
J2 pins 1, 2 (Speed Command Out)..page 2-13
J3 pins 1, 2, 3 (AC Power)..page 2-8
J4 pins 1, 2 (I/O Power)..page 2-7
J5 pin 16 (Drive Enable)..page 2-13
J5 pin 17 (Alarm)..page 2-14
J5 pins 10, 11 (F-Stop)..page 2-11
J5 pins 12, 14 (Master or Follower)..page 2-11
J5 pins 13, 14 (Setpoint Select)..page 2-12
J5 pins 3, 5 (Lead Frequency)..page 2-8
J5 pins 4, 5 (Feedback Frequency)..page 2-9
J5 pins 6, 8 (Run)..page 2-9
J5 pins 7, 8 (Jog)..page 2-10
J5 pins 9, 11 (R-Stop)..page 2-10
Jog..page 3-31, 3-36, Glossary-6
Jog Input (J5 pins 7, 8)..page 2-10
Jog Setpoint..page 3-31, C-1, D-1
K
Keypad
Basic Entry..page 3-4
Error..page 3-45, C-7, E-1
Lockout..page 3-5, C-14, D-1