CONTREX ML-TRIM - Manual (Page 31)

2 - 17
CALIBRATION
Calibration matches the Speed Command analog output of the ML–Trim with the
analog input of the motor drive. Calibration is accomplished in two steps. The first step
is to set up the motor drive. The second step is to calibrate the ML–Trim to the motor
drive so that the speed is adjusted to the maximum operating speed. The ML–Trim
must be properly installed prior to calibration. Refer to
Installation/Setup; Mounting,
page 2-3, and Installation/Setup; Wiring , page 2-5.
Hazardous voltages.
Can cause severe
injury, death or
damage
to the equipment.
Make adjustments with caution.
DANGER