Example, Aastralink pro 160 remote office configuration – Aastra Telecom Pro 160 User Manual
Page 220
Manually Configuring Port-Forwarding
C-10
41-001134-05, Rev 00, Rel. 1.1
AastraLink Pro 160 IP Phone User Guide
Remote Phone Installation and Port-Forwarding Configuration
Example
The following is an example of installing and setting up up your remote phone for
port-forwarding.
AastraLink Pro 160 Remote Office Configuration
Step
Action
Configure Port Forwarding
1
Manually setup the required port forwarding on the Home Router.
Note: Refer to the
“Home Router Port Mapping Table”
on
page C-11
.
Install the Remote IP Phone (Pre-Stage Phone)
2
Press <Remote> when remote phone is in the Auto-Discovery screen.
If the phone cannot find a UPnP enabled device, it displays “UPnP device not found”. Press <Skip>.
The phone prompts for the NAT IP address.
3
Enter the Home Router WAN-side IP address. For example: 65.96.171.130
The phone prompts for the SIP port.
4
Enter the SIP port for the Home Router. For example, you can enter 51620.
The Phone prompts for an RTP port.
5
Enter the RTP port for the Home Router. For example, you can enter 51720.
The Phone prompts for an HTTPS port.
6
Enter the HTTPS port for Home Router. For example, you can enter 51510.
Install the Remote IP Phone (Non-pre-Stage Phone)
7
Press <Remote> and enter the server external gateway IP address (for example, 65.215.35.80).
The Phone prompts for an HTTP port.