CTI Products MCN RCD System Overview - Manual (Page 27)

MCN System Manual Hardware Installation
CTI Products, Inc.
68-10833-120
23
7.3 Mounting Options
Wall mount and EIA 19” rack mount kits are available for MCN modules. These
kits are described below. Some modules may have other mounting options (the
CIB module has a special mounting kit that allows the module to be mounted to
the back of a Digitac comparator). Any alternate mounting options are described
in the specific module’s hardware reference manual.
7.3.1 Wall Mounting
The wall mount option allows a module to be mounted to a flat surface. Screw
holes are provided on the bottom of all MCN modules for attaching the wall
mount bracket(s). Two screw holes are provided on A size MCN modules and
four screw holes are provided on B size MCN modules (refer to Table 1, in
section 1.3, to determine the size of your module). Simply attach the mounting
plate to the bottom of the module using these screw holes and then screw this
assembly to the wall. The module can be mounted in any orientation. Figure 8
shows an exploded view of the wall mount installation.
CA-80026-100
IN OUT NETWORK PWR ACT
ERR
DC IN
OPTION A RESET SVC
1 2 3 4 5 6 7 8 ON
PRODUCTS, INC.
Figure 8 - Wall Mounting
CAUTION
Be sure to use the flat head screws provided with the wall mount kit. If you are
not using the wall mount kit from CTI Products, make sure that the screws do not
protrude into the enclosure more than 1/8 inches from the bottom surface of the
module.
Using a larger screw that touches the PC board inside the module may damage the
module. Doing so will void the unit’s warranty.