CTI Products MCN RCD System Overview - Manual (Page 29)

MCN System Manual Hardware Installation
CTI Products, Inc.
68-10833-120
25
Rack Mounting Instructions
Step Operation
1 Remove all cables from the module.
2 Make sure all screws are installed in the back of the module so that the
PC board will not be able to slide out of the case when the front panel is
removed.
3 Remove the front panel from the module, including the bezel, by
removing the two Philips head screws in the faceplate. The bezel is not
used when rack mounting the module.
4 Position the module behind the bracket, lining up the holes in the
bracket with the front panel screw holes on the module.
5 Position the front panel in front of the bracket, lining the front panel up
with the module.
6 Fasten the front panel and module to the bracket with the screws that
were previously removed.
7 Position the bracket into your rack, lining up the four mounting holes of
the bracket with mounting holes in the rack frame.
8 Position the two spacers in the front of the bracket, aligning the cutouts
in the spacers with the holes of the bracket.
9 Install mounting screws (customer provided) into the rack.
When the module’s front panel is removed, do not allow the PC board to slide out
of the case (this will not happen as long as all screws are installed on the rear
panel of the module). If the PC board does slide out of the case, you must follow
the steps below to replace the PC board in the case.
Re-Installing a PC Board in its Housing
Step Operation
1 From the front of the module, slide the PC board out of the case.
2 Remove the back panel of the module.
3 From the rear of the module, slide the PC board back into the case (there
are markings on the PC board to indicate which edge to insert into the
rear of the case first).
4 Install the back panel of the module.
There is nothing user serviceable inside the modules. Do not attempt to remove
the PC board from its enclosure.