CTI Products MCN RCD System Overview User Manual
Page 30
MCN System Manual
Hardware Installation
CTI Products, Inc.
68-10833-120
26
7.3.3 CIB DIGITAC Mounting
Figure 10 shows the bracket used to mount the CIB module to the rear of the
DIGITAC comparator. This mounting option is only available for the CIB
module.
DIGITAC
CIB
CIB
DIGITAC
P805
P806
CIB DIGITAC MTG. BRKT.
25
50
1
26
FEMALE CONNECTOR
TO PUNCH BLOCK CABLE
IN
OUT
NETWORK
PWR
ACT
ERR
DC IN
OPTION A
RESET
S
V
C
1
2
34
567
8
ON
PRODUCTS, INC.
DIGITAC
QTY (2) 6-32 X 1\4" SCREWS PROVIDED
QTY (2) 8-32 X 3\8" SCREWS PROVIDED
REMOVE THESE (4) SCREWS FROM THE BACK OF THE DIGITAC
AND RE-INSTALL THEM THROUGH THE CIB MOUNTING BRACKET
AS SHOWN ABOVE.
2.181
NOTE ADDITIONAL CLEARANCE REQUIRED BEHIND DIGITAC
WHEN INSTALLING CIB AND BRACKET.
CA-80165-100
Figure 10 - CIB DIGITAC Mounting Bracket
To attach a CIB module to the bracket, and then mount the bracket, follow the
steps below.
WARNING
Be sure to use the screws provided with the DIGITAC bracket kit. If you are not
using the screws provided, make sure that the screws used do not protrude into the
enclosure more than 1/8 inches from the bottom surface of the module.
Using a larger screw that touches the PC board inside the module may damage the
module. Doing so will void the unit’s warranty.