Magnum Venus Plastech Gel Coat Gun EMG-1500 User Manual
Page 19
9.
Install new O-Ring (O-T-010) into Resin Needle Seat area of the Gun Head
(EMG-1001-01)
10. Firmly thread Carbide Seat (MAX-2011-01) into Gun Head (EMG-1001-01).
11. Install new O-Ring (O-S-012) on Seal Housing (MAX-2013) and lightly grease
threads.
12. Install Resin Needle (MAX-2010-01) thru Seal Housing (MAX-2013).
13. Slide Seal Retainer (MAX-2009) then Packing Seal (MAX-2008) over the Resin
Needle (MAX-2010-01).
14. Slide Packing Nut (MG-1022) over the Resin Needle (MAX-2010-01) and thread
into Seal Housing (MAX-2013). Just a little over finger tight
– do not over tighten.
15. Thread Jam Nut (53800-1) then Needle Guide (53900-1) onto resin needle end.
16. Thread Seal Housing and Resin Needle Assembly into the Gun Head (EMG-
1001-01).
NOTE: Use caution not to bend the catalyst and resin needle while performing the
remaining assembly procedures.
NEEDLE GUIDE
JAM NUT
PACKING NUT
PACKING SEAL
SEAL RETAINER
SEAL HOUSING
O-RING
RESIN NEEDLE
CARBIDE SEAT
O-RING
GUN HEAD