Mallory Ignition Mallory PROMASTER IGNITION COILS AND VOLTMASTER MARK II IGNITION COILS 28675_28720 - Manual (Page 4)

4
FIGURES 6 AND 7: DO NOT USE THE IGNITION BALLAST RESISTOR SUPPLIED WITH THE PROMASTER COIL WITH THIS IGNITION SYSTEM.
TACHOMETER/RPM
SENSING LEAD–CONNECT
THE TACH LEAD TO THE
COIL (–) TERMINAL.
12V/IGNITION SWITCH
(ORIGINALLY CONNECTED TO THE
COIL/DISTRIBUTOR CAP)
DISTRIBUTOR PLUG
(ORIGINALLY CONNECTED TO
THE COIL/DISTRIBUTOR CAP)
CENTER WIRE
(BLACK)
NOT USED
GREEN
RED
BLACK
BROWN
MALLORY 8MM SUPPRESSION WIRE
DELCO HEI DISTRIBUTOR
WITH MALLORY HEI REMOTE COIL
ADAPTER INSTALLED
MALLORY ADAPTER/HARNESS PART NO. 29042 WITH
GREEN AND RED WIRES
MALLORY 8MM SUPPRESSION WIRE
PINK OR
RED
MALLORY 8MM SUPPRESSION WIRE
DELCO HEI - INTERNAL COIL
USE MALLORY HEI REMOTE
COIL ADAPTER AND MALLORY
ADAPTER PART NO. 29042
TO INTERCHANGE A
PROMASTER COIL
WITHOUT CUTTING WIRES.
+ –
MALLOR
Y
PR
OMASTER
COIL P
AR
T NO
.
XXXXX
®
MALLORY
ADAPTER
PART NO.
29062 WITH
BLACK,
YELLOW AND
BROWN
WIRES ARE
NOT USED-
DISCARD
BAT PLUG
NOTE: DO NOT USE
IGNITION BALLAST
RESISTOR SUPPLIED
WITH PROMASTER
COIL WITH THIS
IGNITION SYSTEM.
®
+ –
MALLOR
Y
PR
OMASTER
COIL P
AR
T NO
.
XXXXX
®
TO THE DISTRIBUTOR CAP
SUPPRESSION WIRE
MALLORY ADAPTER PART NO. 29068 WITH
GREEN AND RED WIRES.
TO BOTH OF THE
FACTORY HARNESS
PLUGS
(ORIGINALLY
CONNECTED
TO THE COIL)
RED WIRE
GREEN WIRE
MALLORY
ADAPTER
PART NO.
29068 WITH
BLACK AND
YELLOW
WIRES ARE
NOT USED-
DISCARD.
+ –
MALLOR
Y
PR
OMASTER
COIL P
AR
T NO
.
XXXXX
®
TO THE DISTRIBUTOR CAP
SUPPRESSION WIRE
MALLORY ADAPTER PART NO. 29062 WITH
GREEN AND RED WIRES.
TO THE FACTORY
HARNESS PLUG
(ORIGINALLY
CONNECTED
TO THE COIL)
RED WIRE
GREEN WIRE
MALLORY
ADAPTER
PART NO.
29062 WITH
BLACK AND
YELLOW
WIRES ARE
NOT USED-
DISCARD.
FORD TFI SYSTEMS AND MALLORY
ADAPTER PART NO. 29062 TO
INTERCHANGE A PROMASTER COIL
WITHOUT CUTTING WIRES.
®
DELCO HEI - EXTERNAL COIL AND
MALLORY ADAPTER PART NO. 29068 TO
INTERCHANGE A PROMASTER COIL
WITHOUT CUTTING WIRES.
®
®
®
®
NOTE: FIGURES 6, 7 AND 8, IF YOUR
VEHICLE IS EQUIPPED WITH A HYFIRE
ELECTRONIC IGNITION CONTROL OR
SIMILAR AFTERMARKET IGNITION CONTROL,
USE WIRING PROCEDURES AS STATED IN THE
INSTRUCTIONS FOR THE PARTICULAR
IGNITION CONTROL.
MALLORY IS A DIVISION OF THE MR. GASKET PERFORMANCE GROUP
550 MALLORY WAY, CARSON CITY, NV 89701
(775) 882-6600
FAX (775) 887-4326
www.mrgasket.com
FORM 1064
REV. B (9/99)
MADE IN USA
PRINTED IN USA