MaxPower Corp OceanAire Portable - Manual (Page 10)

DISCHARGE AIR NOZZLE KIT ASSEMBLY
CONDENSATE PUMP KIT
A condensate pump kit is designed for automatic
condensate removal system for water dripping off
of the evaporator coil is available.
It is a convenience for those who do not want to
empty the 5.0 gallon condensate tank. It is very
convenient on units that are permamently installed.
This pump is capable of pumping against a 20 foot
head and is controlled by a float/switch mechanism
which turns the pump "on" when approximately 2
1/2 inches of water collects in the tank and
automatically switches "off" when the tank drains
to a level of approximately 1 1/4 inches. A built-in
pump safety switch turns off the air conditioner if
the condensate line becomes plugged or pump
motor failure should occur.
8
The optional Nozzles are used to direct cold air to a specific
area or spot. They are most often applied in commercial and
industrial applications such as production lines to cool people
(making them more productive) or, to cool equipment or
processes.
On PAC10 and 12 units 2 x 4 inch diameter nozzles are used.
On PAC18, 24 and 36 units 2 x 6 inch diameter nozzles are
used. On the PAC60, 32x 8 inch nozzles are used.
NK-1 nozzles have an approximate compressed length of 15
inches. The approximate extended length is 21 inches.
The NK-2 nozzles have an approximate compressed length of
22 inches. The approximate extended length is 32 inches.
NK-3 nozzles are 8 inch in diameter and have an approximate compressed length of 20 inches. The
extended length is approximately 29 inches. They are only used on our 5– ton unit.
The nozzles are made of Virgin PVC 100, ribbon locked, bendable, self-supported, and will not rust or
corrode. In fact, it has excellent resistance to abrasion, solvents, acids and chemicals. The black nozzle tips
(finishing rings) are made of soft plastic and provide an attractive finish and protection from sharp edges.
The nozzles can be “aimed” and will maintain that position until a change is desired.
Nozzles
Duct Flange
DUCT FLANGE
The optional duct flange is attached to the condenser air discharge opening on the top of the unit. Flexible
duct is then attached to it. The DF-12 (12 inch diameter) fits all units except the 5 ton. The DF-16 (16 inch
diameter) fits only the 5 ton Model PAC60.
airbossmanpg8
Low Voltage Molex Connector
Line Voltage Molex Connector