Micromod Micro-DCI: 53HC2600 LoopMaster SL6000 CONFIGURATION TOOLKIT - Manual (Page 13)

53HC2600 INSTRUCTION MANUAL
Installation 5
2.0 INSTALLATION
2.1 Installing LoopMaster
The LoopMaster setup utility installs the program, help file, and the necessary support files onto your hard
drive.
2.1.1 To Install LoopMaster for Windows 3.1 or Windows 95/98
1. Insert the LoopMaster diskette into the floppy drive.
2. From Program Manager, click on the File menu and select Run.
3. In the Run dialog ( Figure 2-1 ), type a:setup and click OK. Type b:setup if installing from
the b: drive. The LoopMaster splash screen will appear while Setup initializes.
4. Setup asks if you want to install LoopMaster onto your hard drive. Click Yes.
5. Depending on your hardware, Setup may make some suggestions. Click OK after reading
any suggestions.
6. Setup asks for the destination drive and directory. Type in the drive and subdirectory where
you want Setup to install all LoopMaster files. If the subdirectory does not exist, Setup will
create it for you. LoopMaster uses a straightforward subdirectory tree where all files are
installed into the same subdirectory.
7. If a warning message appears indicating your system has an old version of SERIAL.386
installed in the Windows System subdirectory, click OK. If the warning message does not
appear, it indicates your SERIAL.386 file is at an acceptable version or it is not used by your
system; proceed to step 9.
8. Microsoft’s instructions to install the SERIAL.386 file appear on the monitor. A copy of these
instructions is provided in
Section 7.0, TROUBLESHOOTING . Do not remove the LoopMaster
diskette from its drive. Follow the Microsoft instructions provided in Section 7.0 to install the
SERIAL.386 file.
Figure 2-1. Run Dialog Box
✎ NOTE Ignore step 3 of the Microsoft instructions, where it states the
WG1001 disk should be inserted into the floppy drive.