Micromod Micro-DCI: 53HC2600 LoopMaster SL6000 CONFIGURATION TOOLKIT - Manual (Page 56)

53HC2600 INSTRUCTION MANUAL
48 Using the Documenter
5.1.4.1 Documenter Title
You can specify up to four lines of text to appear as the title of the report. Each line is centered between
the left and right margins. Decrease the title font size if your title does not fit between the margins.
The Documenter Title will be stored in the .S6D offline configuration file when you do a File > Save opera-
tion, and therefore will only affect this report.
5.1.4.2 Documenter Function Block Overview
The function block overview is a reproduction of the Control Strategy Window. This shows all function
blocks and their interconnections. The font used to draw this diagram is the Control Strategy Window font.
To change this font, use the Options > Font... menu.
The function block overview is scaled to fit between the margins below the title. If this diagram appears
unusually small, try changing the Control Strategy Window font size.
5.1.5 Parameter Listing Pages
Following the title page is a complete listing of all function blocks and parameters used in this configura-
tion. This listing follows the same order and hierarchy used in the Micro-Mite controller. If the FNC or CHR
blocks are configured, then the formula or graph is drawn on a page following the parameter pages.
5.1.5.1 Parameter Listing Format
Use the Documenter > Format... menu to change the appearance of the parameter listing pages. By
changing the tab stop locations, you can move the position of each column. Each tab stop is measured in
inches from the left edge of the page. These settings will be stored in the LOOPMSTR.INI file and affect all
subsequent Documenter Reports.
5.1.6 Rear Connection Diagrams
The Documenter Report includes rear connection diagrams at the end of the report. By using the Doc
Info... buttons, you may greatly enhance the appearance and usefulness of these diagrams by entering
transmitter type, tagname and other rear connection information. All Doc Info... settings are stored in the
.S6D
file when you do a File > Save operation and therefore only affect the current configuration.
✎ NOTE
The CHR or FNC function blocks will be omitted if their mode is
OFF. The cn2 function block will be omitted if a two-loop scheme is
not used.