Micromod Micro-DCI: 53HC2600 LoopMaster SL6000 CONFIGURATION TOOLKIT - Manual (Page 34)

53HC2600 INSTRUCTION MANUAL
26 Guided Tour
6. There are four analog inputs and two digital inputs to the FNC block. Connect AI1 to FNC
input A:
7. Click on the FNC A input button which is on the left of the FNC block next to input A.
8. In the Input Selection dialog for FNC Input A, click on the down arrow to drop down the list.
9. Click on Analog Input AI1, then click OK. A connection is drawn from AI1 to FNC input A, as
illustrated in fig.
10. Click on the Save toolbar button to save these changes to disk. Your changes will be written
to the same file TOUR.S6D.
3.12 Configuring the FNC Block
The FNC function block contains nine mathematical equations and can operate on up to four analog inputs
(A through D) and two digital inputs (E and F). To configure the FNC equation and constants:
1. Click on the FNC button to open the FNC dialog. This dialog shows the analog input sources,
digital input sources, the selected equation, and the six equation constants.
2. The Equations section lists the nine equations supported by the FNC block. Click on the
Algebraic radio button and the equation is drawn as a mathematical formula.
3. Fill in the Equation Constants as shown in Figure 3-11 .
Figure 3-10. Connection Drawing Example, AI1 Source