Important – MotorVac CarbonClean System MCS 245 User Manual
Page 27
10.
When the run time expires, the cleaning is complete. The unit will automatically shut
off and purge the pressure lines for five seconds. The
Cycle Complete
LED on the
control panel will illuminate, and the unit’s alarm will sound.
11.
Turn OFF the vehicle's ignition.
12.
Turn the
Pressure Adjust
regulator counterclockwise on the unit to open it. Press and
hold the
Fill/Purge
button for four seconds to relieve pressure from the output (
red
)
hose. Release the
Fill/Purge
button.
13.
Loosen the vehicle's gas cap to relieve fuel tank pressure, and then re-install cap.
IMPORTANT
Wrap a shop towel around pressure fittings before
disconnection to protect against residual fuel spray.
14.
Disconnect the battery leads, hoses, and adaptors. Return the vehicle's fuel
system to its normal operating condition by re-connecting the vehicle's fuel lines.
15.
Start the vehicle
and verify that there are no leaks.
16.
Test drive the vehicle for three miles immediately following the cleaning service to
flush all detergent from the vehicle's fuel and exhaust systems.