Aiwa CSD-NS1 - Manual (Page 5)

ENGLISH
5
POWER
FUNCTION
En
Remote control
Insert two R6 (size AA) batteries.
• When the reach of the remote control signal is less
than 5 meters (16 feet), replace the batteries.
• Remove the batteries if the remote control is not
going to be used for a long time.
The remote control may not operate correctly
when:
- The unit is exposed to intense light, such as direct
sunlight
- Objects block the remote control signal to the unit
To use the buttons on the remote control
Buttons on the remote control and the main unit with
identical or similar indications have the same functions.
To turn the power on
Press POWER to turn on the display.
To turn the power off
Press POWER to turn off the display.
To use the FUNCTION button
Each time FUNCTION is pressed while the power is on,
the function is selected cyclically.
CD TAPE TUNER
R6 (AA)
Setting the clock
When the AC cord is connected for the first time, the
clock display flashes. Set the time.
1
Press TIMER.
“ 5 ” flashes in the display.
2
Turn VOLUME/TIMER to adjust the clock.
r or t is also available. Holding it down
changes the time in 20-minute units.
3
Press ENTER or a to complete the
setting.
The clock starts from 00 seconds.
NOTE
When the clock is set for the first time, everything on
the display goes out and the POWER
6 STANDBY
indicator lights up. This is because the power
economizing mode is automatically activated. The
power economizing mode can be cancelled (see page
4).
To display the current time
Press TIMER.
To cancel the clock display while the power is on, press
it three times or one of the function buttons. While the
power is off in the power economizing mode, press
TIMER again.
To switch to the 12/24-hour standard
Press TIMER to display the clock and press s .
In the 12-hour standard, “AM 12:00” indicates midnight
and “PM 12:00” indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. Reset the clock.
A long power interruption will clear all the memories
such as preset stations and timer settings.
1
2
3
r , t
s
POWER
6 STANDBY
indicator
3
a
s
r , t