Aiwa CSD-NS1 - Manual (Page 7)

0-9, +10
MODE
EQ
a PAUSE
VOLUME k , i
s
BAND
DISPLAY
r , t
c PLAY
ENGLISH
7
PRESETTING STATIONS
You can preset up to 15 stations in each band.
1
Select a station.
2
Press * a PAUSE/SET once so that
“MEMO” flashes to store the station.
A station is assigned a preset number, beginning
from 1 in consecutive order for each band.
* or a PAUSE on the remote control
3
Repeat steps 1 and 2.
The next station will not be stored if a total of 15
preset stations have already been stored for a
band.
To listen to preset stations
Select a band then press d PLAY/DIR/PRESET
repeatedly.
c PLAY on the remote control is also available.
To select a preset number directly with the
remote control
Press the numbered buttons 0-9 and +10.
Example:
To select number 15, press +10 and 5.
To select number 10, press +10 and 0.
To clear a preset station
Select the preset number first. Press s , and press a
within 4 seconds.
The higher numbers in the band are decreased by one.
En
SOUND ADJUSTMENT
Volume or tone adjustment does not affect
recording.
VOLUME/TIMER (VOLUME)
Turn VOLUME/TIMER, or press VOLUME k or i
on the remote control. The volume level is
displayed as a number 0 to 25 (MAX).
• The volume level is automatically set to 14 if the
power is turned off when the volume level is set
to 15 or more.
• Pressing DISPLAY on the remote control
displays the adjusted volume level.
* 3-MODE EQ (equalizer)
Press 3-MODE EQ repeatedly until the desired
mode is displayed.
The equalizer mode changes to ROCK, POP, JAZZ
or no equalization, cyclically.
ROCK - Emphasizes the high and low range of
music.
POP - Emphasizes voice and midrange of music.
JAZZ - Emphasizes the low range of music.
* or EQ on the remote control
T-BASS system
The T-BASS system enhances the realism of low-
frequency sound.
Press T-BASS to turn it on or off.
QSURROUND system
The QSURROUND system built into this unit uses
only two speakers at the left and right to create an
atmosphere that sounds as if you are surrounded
by two front speakers and two rear speakers.
Press QSURROUND to turn it on or off.
• The QSURROUND system does not work for
monaural sources.
• At higher volumes, turning QSURROUND on
may cause sound distortion. In this case, make
the volume down.
Preset number
Frequency