Multichannel Systems Wireless-System Manual - Manual (Page 30)

Wireless System Manual
26
At first the software detects all Wireless-Systems which are connected to one data acquisition
computer. In "Found W-System SN" the systems are defined by the serial number. You can find
the serial number on the bottom of the receiver and interface board. It is possible to connect,
for example, one W4- and one W8-System. Please set the number of channels of your system
from the "W-Type" drop down menu. Each connected system needs to have a "Frequency ID"
and "each ID must be different".
The letters A, B, C, D denote the connected headstages of the respective system. These letters
are the same as they are used in the MC_Rack hardware dialog.
The Wireless-System Config tool is able to assign one headstage after the other to the respective
Wireless-System.
Please connect the desired headstage to the battery and press the desired button A, B, C,
or D to assign the headstage to A, B, C or D, which is indicated by the green color
in the "Found" button .
To change your selection you can simply choose a new assignment. The information whether
the headstage is A or C for example, will be permanently stored on the headstage and can be
changed at any time. Power the next headstage and assign it to another letter or to another
system with a different "Frequency ID" the same way as described above.
In the screenshot above, different headstages are assigned to the four Wireless-Systems
connected to the data acquisition computer, defined by the "Frequency ID" and the labels
"A", “B”, “C” and "D".