Multichannel Systems Wireless-System Manual - Manual (Page 53)

W8
W16
Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2013 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
ME/W-SG
Signal Generator for the ME-Systems and the Wireless-System
Battery
Dip Switch
Control Button
10-pin single row connector
for W4 and W8 (single row)
and MPA8I headstages.
40-pin Omnetic connector
for W32 headstage and
for μPA32 preamplifier.
20-pin Omnetic connector
for W8 and W16 headstages
and for μPA16 preamplifier.
Connect the W8-headstage (single row connector) of the Wireless-System
to the 10-pin single row precision connector. The W4-headstage needs
an adapter to fit into the single row connector. Connect the μPA32
of the ME-System and the W32 headstage of the Wireless-System to
the 40-pin Omnetic connector. Connect the μPA16 of the ME-System
and the W16 and the W8 (with Omnetic connector) of the Wireless-
System to the 20-pin Omnetic connector.
Connect the wireless headstages W8 and W16 according to the guide posts
as shown on the photos beside. The orientation of the W32 does not matter.
Additionally it is possible to connect the MPA8I-System to the ME/W-SG.
Please insert the MPA8I headstage together with the adapter in correct
orientation into the 10-pin single row connector as shown on the photo
below. The MPA8I headstage is equipped with an 11-pin connector,
that is why one of the pins is not connected. The bottom of the MPA8I
headstage (black side) must show to the bottom of the signal generator.
The free pin of the 11-pin connector must be on the right side.
MPA8I headstage connected to the ME/W-SG
Please connect the MPA8I headstage with
the provided 10-pin double row adapter
in correct orientation to the ME/W-SG.
W4 headstage connected to the ME/W-SG
Please connect the W4 headstage with
the provided 6-pin double row adapter
in correct orientation to the ME/W-SG.
The ME/W-Signal Generator is a very convenient tool for users of the Wireless-System and / or for
users of ME-Systems. Use the ME/W-SG instead of setting up a complete experiment for training,
controlling, and troubleshooting purposes.
MPA8I
W4