American Megatrends X6DVA-EG - Manual (Page 58)

4-6
X6DVA-4G/X6DVA-EG User’s Manual
LBA/Large Mode
LBA (Logical Block Addressing) is a method of addressing data on a disk
drive. In the LBA mode, the maximum drive capacity is 137 GB. For drive
capacities over 137 GB, your system must be equipped with 48-bit LBA
mode addressing. If not, contact your manufacturer or install an ATA/133
IDE controller card that supports 48-bit LBA mode. The options are Dis-
abled or Auto.
Type
Select the type of device connected to the system. The options are Not
Installed, Auto, CDROM and ARMD.
Primary IDE Master/Slave, Secondary IDE Master/Slave, Third
IDE Master/Slave, Fourth IDE Master/Slave Sub-Menu
From the Advanced Setup screen, press <Enter> to access this sub menu
for the primary, secondary, third and fourth IDE master and slave drives.
Use this screen to select options for the Primary and Secondary IDE drives.
Use the up and down <Arrow> keys to select an item. Use the <Plus> and
<Minus> keys to change the value of the selected option.
Combined Mode Operation
This feature allows the user to select the IDE Combined Mode. The
options are: P-ATA 1st Channel and S-ATA 1st Channel.
X X X X X IDE Configuration Sub-Menu
When you select this Sub-menu, AMI BIOS automatically displays the fol-
lowing items:
S-ATA Ports Definition
This feature allows the user to configure Serial ATA Ports. The
options are: P0-Master/P1-Slave, P0-Slave/P1-Master
.
IDE Configuration
This feature allows the user to configure the IDE mode. The options are:
Disabled, P-ATA (Parallel ATA) only, S-ATA (Serial ATA) only, P-ATA &
S-ATA.